Bathroom Heater Accessories

Yes! The digital wall controller emits an audible beep by default whenever a button is pressed to confirm mode selection. If you prefer silent operation, simply press and hold the Standby button for 3 seconds. This will toggle the button-press beep sound on or off.

For maximum comfort and steam control, follow our recommended 3-Step Operation Process: Pre-heat the Room (5 Minutes): Turn on the HEAT function for up to 5 minutes before stepping into the shower. Pre-warming the air and cold wall surfaces significantly reduces condensation formation before steam even starts. Run the Exhaust After Showering: Keep the exhaust running for a few minutes after you finish showering to completely clear lingering humidity. Maintain Cross-Ventilation Placement: Ensure your unit is installed away from corners and positioned between the door (fresh air inlet) and the shower (steam source).

Keep your windows closed for optimal extraction. Counterintuitively, keeping the bathroom window closed produces the best steam removal. Controlled Airflow: Closing the window forces the fan to pull drier air from the rest of the home (usually through the clearance gap under the bathroom door). This sweeps across the whole room, drawing steam away from the shower and straight out the exhaust. Prevents Short-Cycling: If a window right next to the fan is open, the fan will simply pull outside air straight from the window and push it back out, leaving the rest of the room humid and foggy. The Exception: If your bathroom door is completely airtight with zero gap at the bottom, crack the window open slightly so the fan has an air intake source.

No. A single digital wall controller can only be paired with one individual ceiling unit. Because these high-performance units pull up to 2250W each, attempting to bridge multiple heaters onto a single digital control system will severely overload the wall plate circuitry and create an immediate electrical hazard.

Your licensed electrician will follow the detailed schematics supplied inside the unit packaging. Incoming 240V AC mains power connects directly to the main terminal block on the ceiling chassis. The digital wall controller connects to the main unit via dedicated communication wiring. If you choose to utilise the AUX feature for additional lights or a standalone secondary exhaust fan, your electrician will terminate those secondary connections into the available auxiliary terminal inside the main terminal enclosure.

No. The unit's electronic control module is engineered to receive input data from a single master digital controller. Attempting to wire two digital plates together in a 2-way configuration will cause communication bus errors, preventing the unit from turning on.